Separate names with a comma.
Discussion in 'Observed Trials Discussion' started by onza_tpro, May 9, 2004.
post here on how to tightn front freewheels.
Get an air powered hammer gun (you know... hook it up to an air compressor. Maybe there are electric ones. I dunno) and put a small end on it. Take the whole crank and freewheel of of the bike and put it in a vice (by the crank, NOT the freewheel).
Push the gun hard into one of the little indents that you can tighten the freewheel with, keep pushing, and pull the trigger.
The hammer gun will tighten the freewheel really good, just try and hold it in place. This is also a great way of getting freewheels of the crank.
or you can just screw on the fw till its tight, put it on the bike and just push down on the pedal until its completely tight.