FS: Mod Frames, Woodman, Ti Koza

[Motorfiets1234]

Alright people make me an offer. Im looking to get rid of these two frames and get a longer mod frame.... make offer!

P.S. I dont care what offers I get just try and be reasonable. If I get a good offer the frames yours...

Thanks Ben
Motorfiets1234@Hotmail.com

[zoo_mod_rider]

can either of the frames take a seat (my girl friend wants a seat so she can sit down once and a while)?

[rcmalinchak]

I'm almost positive the Koza can take a seat, I haven't seen one in quite a few years, but i think the screw you can see just below the top tube is to tighten to the seatpost.

Ryan

[trialsrider50]

how old is the woodman? any big dings or anything. I'm interested.
don't happen to have a fork as well do ya?

[Motorfiets1234]

the koza will take a seat, ill upload a pic in a bit. the woodman is 2 years old... some minor dings stratches all just cosmetic. small dents on downtube. just 2-3 i think. some small stuff really. no fork unfortunatly....

[Motorfiets1234]

bump.... all offers considered!

[trialsrider50]

just thinking if I can handle a short mod. or are they like monty where the measure the wheelbase before a 40mm fork? i don't think so but if i'm wrong, let me know.

[trialsrider50]

i guess they're not that short. about 1000mm give or take some. I don't want to low ball you man. I'm really just not sure how they hold value. Woodman mods don't seem to be in high demand but I'm not sure. I do need to get some magura mounts if I bought it and I'd like to get a new wheel. My hub is mashed. Let me know what you want for it. PM or just post.

[Motorfiets1234]

BUMP!!!!! Come on now people its a titanium frame!!! I really wanna get rid of both so all offers considered! PM or post if you want more detail pics.

Ill throw in the TI stem as well

[Motorfiets1234]

"Think that project started in '97. AJ Lea rode the mod prototype in '98 season. Funny, we picked a stock bike rider..... hmmmm....

Headtube and bottom bracket shell were 2mm thick! It was burly little frame. Only one that I know of has cracked (Bob;). It was designed to be reasonably light (think the bike was around 20 or 21 pounds) and durable. Geometry was largely Megamo of that era.

There were only a total of 22 ever made. First one was prototype.... then sold to Joe (much to Mikes shagrin). Then there was two batches of ten. In the first batch were a couple for JJ Gregorowicz.... one of which we had the factory hand polish. Then one more came from the factory sometime in '99... and went to the D-Man we still has it today.

I notice there is Plazmatic cranks on the one in the pic. Think we only had ten pairs of those made. They were pretty damn stiff. Think there was an issue with threads that held in chainring if memory is correct....

The pic above looks to be totally stock. We equipped them with Tioga straight pull spoke front hubs...... Club Roost front tire.... yep Mike, that looks to be Plazmatic (aka Monty/Megamo re-label) rear tire, Megamo bar, Ti stem etc... Yes, the stems were 10mm too short.... factory goofed."

- Quoted by Tim over at trialsin.com

[Motorfiets1234]

bump